Sketch dump

This blog has been neglected a bit. So to keep it ticking along and try and reapply some pressure on myself, here's a few bits from the last few months.

I found out in a dream that the internet is actually located on an Island in the South Pacific called Filutia, or something like that. Somehow some South American Amerindians got there and built cubic mega-bunkers sunk into the ground, which were then used as an isolated place to bury the internet.

Caracter / costume design inspired by an Oni Ayhun track.

Tomorrow morning.

Woodland

A bit of concept art for a film. Character design for a (possibly malevolent) woodland spirit. Who you gonna call?

Anvil: The Story of Anvil

For some reason I became a bit preoccupied with the icon of a proper ACME anvil a while ago (something to do with effort and work) and had a mental image of a glowing concrete anvil on the wall. It felt like a memento mori — some reminder to stop dicking about and make something.

There were lots of experimental batches with different concrete recipes. Sand, aggregate, glass spheres, chopped glass fibre, PVA, talc powder, cement all in varying proportions.

Jigsawed in MDF.

It took much more than this.

Steel mesh reinforcements. It wasn't going to take much mechanical stress but many of the test pours didn't feel strong enough.

Fine white sand and cement only.

Lucky accident! The concrete didn't fully slump around the mesh so left these small voids through to the rusty steel. I was initially going to use the other side, but preferred this.

Thin backing form cut and epoxied to the cast, then wrapped with LED strip lights.

I packed more iron powder into the cavities and rusted with peroxide-salt-vinegar mix.

Fin.

Carnegie Hall.

A few more. The tip of the tip of the iceberg.. Between 30 second and 30 minute poses.

Lorra lorra sketching

Despite the lack of updates I've been churning out quite a bit of 'work'. Much life drawing, a few down below (the tippity tip of the iceberg). All charcoal on sugar paper, newsprint, or primed cardboard.

Because we love you..

I found an old CCTV camera in a skip while on a job, and now I done an idea...

Original condition — cracking, flaking paint and lots of crumbling, oxidised metal.

Gutted, a few of the electrics can be cannibalised and used for the lighting.

Stripping the remaining paint back. Nitro Mors is pretty nasty stuff it turns out. Gets right up your beak and needs a fair dash of tonic to go down.

Grinding and sanding away the oxidised metal and the last of the paint.

Primed and ready to paint.

Several dustings of paint and a few layers of clear coat later...

Seated an LED light (low temperature so it doesn't melt anything or burst into flames) in a block of blue foam and coated the inside with aluminium foil tape.

All wired up and ready to test.

Next frosted the glass and figured out how to put it all back together again.

Just have to find/make a bracket to fit it to the wall and its done.